default or selected kernelversion does not have config value CONFIG_IBMMCA_SCSI_DEV_RESET.
Result is shown for kernelversion 6.2.5
Reset SCSI-devices at boottime
configname: CONFIG_IBMMCA_SCSI_DEV_RESET
Linux Kernel Configuration
└─>Device Drivers
└─>SCSI device support
└─>SCSI low-level drivers
└─>Reset SCSI-devices at boottime
In linux kernel since version 2.6.20 (release Date: 2007-02-04)
By default, SCSI-devices are reset when the machine is powered on.
However, some devices exist, like special-control-devices,
SCSI-CNC-machines, SCSI-printer or scanners of older type, that do
not reset when switched on. If you say Y here, each device connected
to your SCSI-bus will be issued a reset-command after it has been
probed, while the kernel is booting. This may cause problems with
more modern devices, like hard disks, which do not appreciate these
reset commands, and can cause your system to hang. So say Y only if
you know that one of your older devices needs it; N is the safe
answer.
However, some devices exist, like special-control-devices,
SCSI-CNC-machines, SCSI-printer or scanners of older type, that do
not reset when switched on. If you say Y here, each device connected
to your SCSI-bus will be issued a reset-command after it has been
probed, while the kernel is booting. This may cause problems with
more modern devices, like hard disks, which do not appreciate these
reset commands, and can cause your system to hang. So say Y only if
you know that one of your older devices needs it; N is the safe
answer.