Cache Hermes firmware on driver initialisation
configname: CONFIG_HERMES_CACHE_FW_ON_INIT
Linux Kernel Configuration
└─>Device Drivers
└─>Network device support
└─>Wireless LAN
└─>Cache Hermes firmware on driver initialisation
In linux kernel since version 2.6.29 (release Date: 2009-03-23)
Say Y to cache any firmware required by the Hermes drivers
on startup. The firmware will remain cached until the
driver is unloaded. The cache uses 64K of RAM.
Otherwise load the firmware from userspace as required. In
this case the driver should be unloaded and restarted
whenever the firmware is changed.
If you are not sure, say Y.
on startup. The firmware will remain cached until the
driver is unloaded. The cache uses 64K of RAM.
Otherwise load the firmware from userspace as required. In
this case the driver should be unloaded and restarted
whenever the firmware is changed.
If you are not sure, say Y.